GO025

– Kit for removing the inner bearing rings, which usually remain on the wheel hub when replacing wheel bearings.
– New design for large bearing rings, which cannot be removed with kit GO020.
– The exclusive gripper principle is effective even when the bearing ring is flush with the hub.
– The bearing ring is held firmly around its entire circumference and removed without tilting it.

Application
Universally applicable to cars and vans, as well as to bearing rings in general (e.g. gears, etc.)

Components
1 x base unit including the M22 spindle and the pressure cone, 5 pcs.
1 x clamping sleeve Gr. 1 Ø60 – 64mm e.g. for Mercedes W201 – W202 – W203 – W210 – W214 / BMW / Peugeot
1 x clamping sleeve Gr. 2 Ø64 – 68mm e.g. for Mercedes W163 – W140 – W169 – W211 – W220 – W245 – W124T
1 x clamping sleeve Gr. 3 Ø68 – 72mm
       e.g. for VW Touareg / Porsche Cayenne
1 x clamping sleeve Gr. 4 Ø72 – 76mm e.g. for Mercedes ML164 – ML166 / Renault Master – Opel Movano – Nissan NV400 (2010→)
1 x clamping sleeve Gr. 5 Ø76 – 80mm e.g. for VW-Audi with bolted wheel bearing
2 x wrench
1 x lubricating grease for high-performance spindles