Govoni Catalogue ›HEAVY VEHICLES›SILENT BLOCKS›GO1310
GO1310
MASTER SILENT BLOCK EXTRACTION/FITTING KIT FOR HEAVY VEHICLES
Description
The kit is needed for the correct removal and fitting of the suspension bushes of heavy vehicles.
With the aid of the vice block and the relevant half-rings, the bushes can be pre-tensioned in parallel and without damaging them, to allow them to be conveniently inserted into their seat on the vehicle afterwards. In addition, the accessories contained in the kit also make it possible to extract old bushes. The tools can be used directly on the vehicle without laborious dismantling of entire axle and suspension components. The pressers can also be used on the workshop press.
The kit is suitable for a wide selection of the most common uses, with broad market coverage. Other half-ring kits (different sizes) will be available in the future on request.
In view of the sometimes enormous forces required, especially during removal, the use of a hydraulic cylinder is recommended. The Govoni 17 ton hydraulic cylinder is therefore ideally suited as a complement.
Application
- Ø 75mm MB Actros (stabiliser)
- Ø 70mm MAN
- Ø 68mm MAN (front spring) ROR, SAF
- Ø 66mm IVECO Eurostar (driver’s cab)
- Ø 65mm MB Actros (stabiliser), Atego
- Ø 63mm DAF
- Ø 60mm MB/IVECO Eurostar (stabiliser), Renault Kerax, Magnum, Premium (spring bush)
- Ø 58mm MB 3229 B, 652, 650/Volvo
- Ø 56mm IVECO Eurostar (driver’s cab)
